AeroPro Button Interface

October 29, 2020 in Support

The AeroPro is a simple single button interface. The purpose of the buttons is to put the AeroPro to sleep when not in use and wake up prior to a test. It is recommend that when not in use the AeroPro is plugged in and charging so it is ready at a moments notice. Currently the procedure to put the AeroPro asleep is to hold the button down for 5 seconds and release, the button is a soft press and excessive force should not be needed. You should feel a subtle click as the enclosure depresses the internal button.

There is a known issue where if the button is held longer than 5 seconds the sensor will reboot immediately, this will be fixed in a future firmware update.

When asleep all of the LED lights will turn off even if the AeroPro is plugged in. Wake the AeroPro to check the charge status visually.


Still having troubles? Contact support.